Low Battery; Oil Change - Dometic BLUTEC 40D Manual De Instrucciones Para El Uso, Mantenimiento E Instalación

Problem
The unit is not delivering power
The unit starts and accelerates
GB
strongly, then stops and the
message "generator alert" is
displayed
The power supplied is not
constant
TABLE OF ALARM SIGNALS
If the problem or malfunction encountered is
not listed in the table, you should check the
Alarm

LOW BATTERY

OIL CHANGE

NO FUEL
OIL TEMP PRESS
GENERATOR ALERT!
OVERLOAD!
SHORT CIRCUIT
OVER TEMPERATURE
LOW POWER ENGINE
Cause
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
The inverter is broken
The inverter is broken
Malfunction in the pump power
supply
The power cables are
disconnected or they do not
provide a continuous supply
Injectors dirty or faulty
Air filter blocked
Cooling air/water pipe blocked
Voltage required higher than 3,5
kW
Problem
Battery low
Indicates that it is necessary to
change the engine oil
Fuel level too low
Insufficient oil in engine
Exhaust gas temperature too high
General alarm
Voltage required higher than 3,5 kW Decrease the required load
Output cable short-ircuit
Inverter overheating
Engine revs too low
- 30 -
Remedy
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Clean the air filter
Check the cooling air/water pipe
and clean it if necessary
Decrease the required voltage load
"Alarm signals" table given below.
Remedy
Change the battery
Change the engine oil (see "Changing
engine oil")
Important
On restarting the unit, keep the start
switch pressed for a long time to
reset the hour counter.
Fill up with fuel
Top up with oil of the same type
Check the cooling air/water pipe and
clean it if necessary
See "Finding malfunctions"
Important
If the problem persists, contact the
service department
Eliminate the short-circuit
Switch the appliance off and leave it to
cool.
Decrease the required load
User manual