Connecting The Starter Battery - Dometic ePower T Instrucciones De Montaje

All manuals and user guides at all-guides.com
Connecting the electrical power to the generator
8.3 Connecting to eCore
➤ Guide the ePower cable (fig. g 1, page 14) to the eCore (fig. g 2,
page 14).
➤ Connect the wires (fig. g, page 14).
8.4

Connecting the starter battery

A
NOTICE!
The starter battery must have 12 V and a capacity of at least
60 Ah.
➤ Fit a 100 A fuse in the positive cable near the positive terminal of the
starter battery to protect the generator's electrical system.
➤ Connect the positive terminal of the battery (fig. g 3, page 14) to the
positive battery terminal connection using a suitable cable (fig. g 4,
page 14):
– cable length < 6 m: cross-section of 10 mm²
– cable length > 6 m: cross-section of 16 mm²
➤ Connect the negative terminal of the battery (fig. g 3, page 14) using a
cable with a suitable cross-section (see above) as follows:
– to the earth connection on the generator (fig. h 1, page 15) or
– via the inserts at the side of the generator (fig. h 2, page 15)
➤ Connect the earth connection on the generator to the vehicle chassis.
Remove any paint or rust from the chassis if necessary to ensure good
contact.
➤ Protect the connections by applying an anticorrosion product (e. g.
grease, lubrication/protection spray).
8.5 ePower T only: Connecting the float
➤ Push the plug supplied into the socket of the orange cable.
➤ Connect the orange cable to the float connection (fig. e 6, page 10).
36
ePower T, ePower T LPG
EN