Changing Engine Oil - Dometic BLUTEC 40D Manual De Instrucciones Para El Uso, Mantenimiento E Instalación

CHANGING ENGINE OIL

Proceed as indicated.
1 -Turn the unit off.
2 -Leave the unit to cool
down sufficiently, to
avoid the risk of burn-
ing.
3 -Open the door (A).
4 -Provide a container of
sufficient capacity.
For the amounts of
oil, see "Technical da-
ta".
5 -Extract the dipstick
(B).
6 -Unfasten the screw
(C) to extract the pump (D).
7 -Adjust the pump man-
ually to drain all the oil
into the container.
8 -Replace the pump (D)
in its housing and fix it
with the screw (C).
9 -Pour in the new oil until
reaching the correct
level on the dipstick
(B) (see "Check oil
level").
10 -Replace the dipstick
(B).
11 -Close the door (A)
when the operation
has been completed.
12 -Turn the unit on and allow it to warm up
for a few minutes.
13 -Turn the unit off and check the oil level
(see "Check oil level").
rod (B)
door (A)
pump (D)
Important
Do not discard used oil, but hand it over to
an authorised disposal organisation in
compliance with current local laws.
Use oils and lubricants of the types rec-
ommended by the manufacturer.
- 27 -
screw (C)
pump (D)
IDM - 40200701800.tif
rod (B)
IDM - 40200701900.tif
User manual
GB