Cleaning The Fan Filter; Cleaning The Bottom Element Reflector; Cleaning The Touchscreen Control - Hatco Toast-Qwik TQ3-500 Serie Manual De Instalación Y Operación

Cleaning the Fan Filter

A cooling fan filter is located on the bottom of the unit. This
filter should be checked/cleaned monthly and anytime "Routine
Maintenance; Clean Fan Filter" appears on the touchscreen.
Use the following procedure to clean the filter.
1. Perform the "Shutdown" procedure in the OPERATION
section, and unplug the power cord.
2. Using the filter handle, slide the filter out of the filter
housing.
3. Rinse the filter using hot water. Allow the filter to dry
completely.
4. Slide the filter back into the filter housing.
NOTE: The filter can be installed from either side of the toaster.
Toast tray removed
for clarity in view
from bottom.
Cleaning the Filter
Form No. TQ3CEM-0618
Cooling
Fan
Filter
Filter
Filter
Housing
Handle

Cleaning the Bottom Element Reflector

The bottom heating element reflector inside the toasting
chamber has slots that allow bread crumbs to drop through to
the crumb tray. Over an extended period of use, bread crumbs
may build up on the reflector and not drop through onto the tray.
1. Perform the "Shutdown" procedure in the OPERATION
section, and unplug the power cord.
2. Wipe the crumbs onto the crumb tray using a bristle brush.
• To wipe the reflector, place the bristle brush through the
conveyor belt and wipe to each side.
3. Perform the "Daily Cleaning" procedure in this section.

Cleaning the Touchscreen Control

Dirt and grease will build up on the touchscreen control over an
extended period of use. Use the following procedure to clean
the touchscreen control and maintain performance.
1. Perform the "Shutdown" procedure in the OPERATION
section, and unplug the power cord.
2. Spray a mild degreaser onto a soft, damp non-abrasive
cloth, and wipe the entire touchscreen until clean. Repeat,
if necessary.
3. Allow the touchscreen to dry completely.
4. Wipe away any hazy residue that remains on the
touchscreen using a clean, dry non-abrasive cloth.
13
MAINTENANCE