Connections; For Models With Factory Nav - Metra 99-7620B Instrucciones De Instalación

From the 20-pin harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Connect the Blue/Pink wire to the speed sense wire (if applicable).

CONNECTIONS

7620-NAV harness (for models with factory navigation)
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to retain steering
From the 32-pin harness with RCA jacks to the aftermarket radio:
• If retaining the factory AUX-IN jack, connect the Red and White RCA jacks labeled "AUX
• Disregard the Red and White RCA jacks labeled "From DVD", they will not be used in this
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Input" to the AUX input.
application.
Continue to Installation
9
REV. 5/24/2019 INST99-7620B