With Bose Amplifier - Metra 99-7620B Instrucciones De Instalación

For models with a BOSE amplifier:
From the 20-pin harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Tape off and disregard the following (9) wires, they will not be used in this application: Gray,
Gray/Black, Green, Green/Black, Purple, Purple/Black, White, White/Black, White/Blue.
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• If retaining the factory AUX-IN jack, connect the Red and White RCA jacks labeled "AUX
Input" to the AUX input.
• Disregard the Red and White RCA jacks labeled "From DVD", they will not be used in this
application.
• Disregard the Yellow RCA jack labeled "From DVD", it will not be used in this application.
Note: This 16-pin harness must be connected for the factory backup camera to function.
There are (2) 16-pin harnesses in the vehicle. Use the 16-pin harness that was connected into
the factory radio chassis.
• If an aftermarket backup camera or external video source is desired to be displayed to the
factory display screen, connect the Yellow RCA jack labeled "Backcam" to the desired source.
8
CONNECTIONS
7620-MAIN harness (for models without factory navigation)
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to retain steering
From the 12-pin harness with RCA jacks to the aftermarket radio:
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
• Connect the White RCA to the left front RCA output.
• Connect the Gray RCA to the right front RCA output
• Connect the Green RCA to the left rear RCA output.
• Connect the Purple RCA to the right rear RCA output.
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1
sound from the factory amplifier.
Continue to Installation
|
1.800.221.0932 MetraOnline.com