For models without factory navigation:
With the key in the off position:
1. Connect the 7620-MAIN harness into the interface, and then to the wiring harness in the
vehicle.
2. Connect the 20-pin to 24-pin interface to display harness into the interface, and then to
the 24-pin display harness in the vehicle.
3. Connect the 12-pin harness with RCA jacks to the wiring harness in the vehicle.
Attention! Extreme care must be taken when inserting the following harnesses. They can be
forced in backwards and can permanently damage the kit if so.
4. Connect the 14-pin to 14-pin HVAC control panel to interface harness into the interface,
and then to the HVAC control panel.
5. Connect the 10-pin to 10-pin HVAC control panel to outboard control panel harness into
the HVAC control panel, and then to the outboard control panel. The right side connector
on the HVAC control panel will go to the right side outboard control panel, and likewise
for the left side.
10
INSTALLATION
For models with factory navigation:
With the key in the off position:
1. Connect the 7620-NAV harness into the interface, and then to the wiring harness in the
vehicle.
2. Connect the 20-pin to 12-pin interface to display harness into the interface, and then to
the 12-pin display harness in the vehicle.
3. Connect the 32-pin harness with RCA jacks to the wiring harness in the vehicle.
Attention! Extreme care must be taken when inserting the following harnesses. They can be
forced in backwards and can permanently damage the kit if so.
4. Connect the 14-pin to 14-pin HVAC control panel to interface harness into the interface,
and then to the HVAC control panel.
5. Connect the 10-pin to 10-pin HVAC control panel to outboard control panel harness into
the HVAC control panel, and then to the outboard control panel. The right side connector
on the HVAC control panel will go to the right side outboard control panel, and likewise
for the left side.
|
1.800.221.0932
MetraOnline.com