Preparing The Lawn Mower For Operation; Charging The Battery, Leds; Charging The Battery; State Of Charge - Stihl RMA 235 Manual De Instrucciones

Ocultar thumbs Ver también para RMA 235:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
5 Preparing the Lawn Mower for
Operation
5.1

Preparing the Lawn Mower for Operation

The following steps must be performed before commencing
work:
► Make sure that the following components are in safe
condition:
– Lawn mower, @ 4.6.1.
– Blade, @ 4.6.2.
– Battery, @ 4.6.3.
► Check the battery, @ 11.3.
► Fully charge the battery, @ 6.1.
► Clean the lawn mower, @ 16.2.
► Check the blade, @ 11.2.
► Attach the handlebar, @ 7.1.
► Fold up the handlebar, @ 7.2.1.
► If mowing and the mown grass is to be collected in the
grass catcher box: attach the grass catcher box, @ 7.3.2.
► If mowing and the mown grass is to be ejected to the rear:
detach the grass catcher box, @ 7.3.3.
► Set the cutting height, @ 12.2.
► Check the controls, @ 11.1.
► If the 3 LEDs flash red during the check of the controls:
pull out the activation key, remove the battery and
consult a STIHL specialist dealer.
There is a fault in the lawn mower.
► If the steps cannot be performed: do not use the lawn
mower and consult a STIHL specialist dealer.
12
5 Preparing the Lawn Mower for Operation

6 Charging the Battery, LEDs

6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.1.
There is a malfunction in the mower or battery.
80-100%
60-80%
40-60%
20-40%
0-20%
0478-131-9541-A

Publicidad

Tabla de contenido
loading

Tabla de contenido