Original Accessories / Attachments; Safety Instructions For Fine Spray Systems - Parkside PDFP 500 A1 Instrucciones De Utilización Y De Seguridad

a danger of suffocation! Work in well
ventilated spaces only.
DANGER OF INJURY!
Never exceed the maximum allowable working
air pressure of 3 bar. Use a pressure reducer
to set the working air pressure.
DANGER OF INJURY! IMPROPER USE!
Never point the device at people or animals.
DANGER OF / EXPLOSION AND FIRE
SMOKING PROHI BITED! Do not ignite
any sparks or open flames.
DANGER OF INJURY!
Never use oxygen or other combustible gas as
the energy source.
DANGER OF INJURY!
First disconnect the hose from the
compressed air source and only then
disconnect the compressed air supply
hose from the device. This will ensure that
the compressed air supply hose does not wave
around or recoil in an uncontrolled manner.
For your own safety, wear suitable
personal protective equipment. Wear
respiratory protection with active charcoal fil-
ters and goggles.
Keep children and other people away
while you are operating the device.
Distractions can cause you to lose control of
the device.
D isconnect the device from the compressed air
source before carrying out any repair or main-
tenance work, during interruptions to operations
and before transporting the device.
W hen removing the hose coupling, hold the
hose tightly in your hand to avoid injury
caused by the hose shooting backwards.
L ook out for damage on the device.
Check the device for damage before bringing
it into use. Do not use the device if you discover
any defects.
D o not kink the device's hose, otherwise you
may damage it.
Please note the safety instructions of the ma-
nufacturer of the sprayed material.
R emain alert at all times, pay attention
to what you are doing and use common
sense in your work. Do not use any
device when you are tired or under the
influence of drugs, alcohol or medica-
tions.
D o not remove rating plates or labels - they are
safety-relevant parts of the device.
I f you are inexperienced in the use of this type
of device, you should seek out information or
training to learn how to handle it safely.
Original accessories /
Q
attachments
U se only the accessories and attach-
ments detailed in the operating instruc-
tions. The use of accessories other than those
recommended in the operating instructions could
lead to you being in danger of injury.
Safety instructions for
Q
fine spray systems
K eep your work area clean, well lit
and free of paint or solvent containers,
rags and other combustible materials.
Potential danger of spontaneous combustion.
Keep fully functioning fire extinguishers / extin-
guishing equipment available at all times.
E nsure good ventilation in the spray-
ing area and sufficient quantities of
fresh air through-out the room. Evapo-
rating flammable solvents create an explosive
environment.
D o not spray or clean with materials
with a flashpoint below 21°C. Use
materials on the basis of water, low-
volatile hydrocarbons or similar ma-
terials. Highly volatile evaporating solvents
create an explosive environment.
D o not spray in the area of ignition
sources such as static electricity sparks,
open flames, pilot lights, hot objects,
motors, cigarettes and sparks from in-
serting and disconnecting power cords
or the operation of switches. Such sources
of sparks can lead to ignition of the surround-
ing area.
Safety advice
GB/MT 31