Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SEQUENCE
1
2
3
4
5
6
7
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example, if you are in colour 5, by
pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If you are in sequence 7, press once and you will get to
colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
6.2. COLORPLUS TOP: Modulator control and/or Remote control
The system has 21 operation modes: 12 set colours and 9 sequences of different colours (see section 6.2.2.).
The Modulator controls switching the spotlights on and off, changes of colour and sequences and switching off timing.
If you have a remote control, apart from the Modulator operations, you can also switch colours of a sequence on and off and select the switching off
time.
6.2.1. Electrical connection diagram
For correct installation, you will need the Modulator, the transformer and finally the leds lamp. As an option, this system can be controlled by Remote
Control. For more information on the installation of the Modulator, see point 6.2.3. and section 6.2.4. includes information on the Remote Control.
The Modulator is connected to the 230 Vac mains by means of two terminals indicated RED, and to the primary input of the transformer (230 Vac)
by means of the terminals indicated TRF (See attached diagram).
The transformer must have the capacity to supply VA to each led spotlight connected.
Each Modulator can control up to a maximum of 15 spotlights 41636 or 7 spotlights 41627
Remote Control
(optional)
Once the unit is connected, proceed as follows to start-up the projector for the first time:
• Switch on the unit by activating the 230 Vac. at the input of the Receiver-Modulator, which will automatically syntonize with the transformer. The
green led of the Receiver-Modulator will flash every 2 seconds and the spotlight will remain off.
Linking the Remote Control and the Modulator:
• Press key
(Off) of the Modulator continuously. The green led will start to flash quickly indicating that it is in the Learning mode.
• Press any of the other keys of the control: COLOR, SEQUENCE or SPEED. If you have several Remote Controls (maximum 8), repeat the operation
so that the Modulator responds to the orders of all of them.
6.2.2 Types of lighting
The Remote Control – Modulator – Transformer – Led Projector unit enables you to create different lighting settings inside the pool with two operation
options:
Set colour: Selection of a set colour among twelve possibilities.
Selecting the sequence
The set to select 1 sequence of the 8 available in the system. Press once to change sequence. Once you reach the last sequence press once to return
to the first sequence. All the sequences are cyclic, that is, on reaching the last colour they start again.
ORDER OF COLOURS
Red
Blue
Green
Purple
Red
Green
Cyan
Blue
Purple
Cyan
Yellow
-
Red
Blue
Green
-
Purple
Cyan
Yellow
-
Yellow
Purple
Cyan
-
Green
Red
Blue
-
1
Red
2
Green
3
Blue
4
Yellow
5
Cyan
6
Purple
COLOUR TIMING
(SEC.)
Cyan
Yellow
2
Purple
Yellow
4
-
-
4
-
-
8
-
-
18
-
-
0,5
-
-
0,5
7
Sky-blue
8
Pale Violet
9
Orange
10
Magenta
11
Emerald green
12
White
4
BLENDING
TIMING (SEC.)
2
4
4
8
18
0,5
0,5
Publicidad
Tabla de contenido
