QSC CMX Serie Manual Del Usuario página 19

Specifications
Stereo Mode (both channels driven)
8Ω / FTC 20 Hz - 20 kHz / 0.1% THD
8Ω / EIA 1 KHZ / 0.1% THD
4Ω / FTC 20 HZ - 20 KHZ / 0.1% THD
4Ω / EIA 1 KHZ / 1% THD
2Ω / EIA 1 KHZ / 1% THD
70 V - Direct drive / EIA 1 kHz / 1% THD
100 V - Direct drive / EIA 1 kHz / 1% THD
Bridge Mono Mode
8Ω / FTC 20 Hz - 20 kHz / 0.1%THD
8Ω / EIA 1 kHz / 0.1%THD
4Ω / EIA 1 kHz / 1%THD
140 V - Direct drive / EIA 1 kHz / 1% THD
100 V - Direct drive / EIA 1 kHz / 1% THD
Distortion (SMPTE-IM)
Signal to Noise (20 Hz – 20 kHz) 8Ω
Input Sensitivity 8Ω
Voltage Gain (8Ω)
Output Circuitry
Power Requirements
Typical, 1/8 power, pink noise at 4Ω
120 VAC
230 VAC
Severe, 1/3 power pink noise at 4Ω
120 VAC
230 VAC
Frequency Response
Damping Factor
Input Impedance (Ω)
Input Clipping
Cooling
Connectors (each channel)
Controls
Indicators
Amplifier Protection
Load Protection
Dimensions (HWD)
Weight - Net / Shipping
Specifications subject to change without notice.
CMX 2000V
1050 W
1100 W
1600 W
2000 W
2500 W
2500 W
1000 W
3200 W
3600 W
5000 W
5000 W
3600 W
< 0.01%
> -100 dB
1.42 V (+5.3 dBu)
36 dB
3-tier Class H
13.9 A
7 A
26.9 A
13.5 A
20 Hz – 20 kHz, +/- 1 dB dB -3 dB points: 5 Hz and 50 kHz (LF filter bypassed / 8Ω)
> 300 at 8Ω
10 kΩ unbalanced / 20 kΩ balanced
6.4 Vrms (+18 dBu)
Continuously variable speed fan, back-to-front air flow
Input: Active balanced; barrier strip, XLR and 1/4" (6.3 mm) - TRS tip and XLR
(pin 2 positive)
Output: Detachable terminal block and Speakon™
Front: AC Switch, Channel 1 and Channel 2 gain knobs
Rear: 10-position DIP switch
Power-on: Green LED / Signal: Green LED (1 per channel) / Clip: Red LED
(1 per channel)
Stable into reactive or mismatched loads
On/off muting, triac crowbar on each channel
5.25" (3RU) x 19" x 15.9" (133 mm x 483 mm x 400 mm)
75 lb (34 kg) / 87 lb (39.5 kg)
18