QSC CMX Serie Manual Del Usuario página 11

The Difference Between Modes
STEREO Mode
STEREO mode is the typical way of using the amplifier. Each channel is fully independent. Separate signals connect at the inputs, the attenuation knobs
control their respective channels, and separate speakers connect to each output. The dip switches are set as shown in
18).
tion in (Figure
Examples:
• Two-channel (stereo) playback.
• Two independent mono signals, such as main and monitor mixes.
• Bi-amped operation, with the low frequencies in Channel 1 and the highs in Channel 2.
— Figure 17 —
PARALLEL INPUTS Mßode
This mode is similar to the STEREO mode, except that the inputs for Channel 1 and Channel 2 are internally connected together. A signal into
Channel 1 jack drives both channels directly
attenuation control still functions as usual, and each channel feeds its own speaker load. The dip switches are set as shown in
In PARALLEL INPUTS mode, you can patch the input signal on to additional amplifiers by using any of the remaining input jacks.
See Ch 2 in (Figure 19).
Example:
• One mono signal driving both channels, with independent attenuation control for each speaker system.
— Figure 20 —
(Figure 19). Use Channel 1 Input, do not connect different sources to both channels. Each channel's
10
— Figure 18 —
signal input
NO INPUT!
Can be used to Daisy-chain
additional amplifiers
Amplifier #2
— Figure 19 —
(Figure 17), a schematic illustra-
(Figure 20).