QSC CMX Serie Manual Del Usuario página 15

Terminal Block Connector
The terminal block connector requires the following assembly.
1. Strip the wires to 7 ~ 8 mm.
2. Insert the wires into the male part of the connector according to the operating mode you are using. See
3. Use a flat-tip screwdriver to secure the wires. Tighten the screws to 6 in.-lbs.
4. Insert the plug into the receptacle on the amplifier.
5. Use a flat-tip screwdriver to secure the connector. Tighten the screws to 6 in.-lbs.
STEREO and PARALLEL INPUTS mode:
Wire as shown by loudspeaker symbols 1 and 2 on the back of the amplifier, and as shown by the solid wires in the diagram.
BRIDGE MONO mode:
Wire as shown by BRIDGE MONO loudspeaker symbol on the amplifier, and as shown by the dashed wires in
— Figure 31 —
Terminal Block Connector Wiring
Wire range
Solid wire (AWG)
Stranded wire (AWG/mm )
2
Torque (lb.-in.)
Wire strip length
— Table 3 —
UL
- 6 mm
28 – 10
28 – 10
6
7 – 8 mm
14
(Figure 31).
(Figure 31).
IEC
2
-
-
-
-