ABB Orion3 Extended Instrucciones Originales página 9

The Alignment mode is activated by pushing the RESET push-button for at least 0.5 s at power on.
1 ) Keep the active unit in a steady position and adjust the passive unit until the yellow LED (
This condition shows the alignment of the first transmitter/receiver couple.
2 ) Rotate the passive unit, pivoting around the lower optics axis, until the yellow LED (
NB: Make sure that the green LED (
3 ) Slightly turn both units both ways to find the limits of the area in which the green LED (
displayed (Maximum alignment). Place both units in the center of this area.
4 ) Fix the two units firmly using brackets.
Check that the green LED (
the red LED ( ) turns on when one single beam is interrupted. This check shall be made with the special
cylindrical "Test Piece" having a suitable size for the resolution of the device used (see paragraph "Checks after
first installation" of the instruction manual).
5 ) Switch the device off and on to normal operating mode.
Display
2TLC172298M0201
2015-09-15
) is on and steady.
) on the active unit is on when the beams are not interrupted Then check that
Alignment status
First and last couple are not aligned
Last couple is not aligned
First couple is not aligned
Every couple over the lower light reception
threshold and no couple over the upper
light reception threshold
Every couple over the lower light reception
threshold and one couple over the upper
light reception threshold
Every couple over the upper light reception
threshold
Alignment
quality
Bad
Bad
Bad
Good
Excellent
9
FIRST) turns off.
LAST) turns off.
) is steady and "3" is
Output status when
out of alignment
mode
OSSD OFF
OSSD OFF
OSSD OFF
OSSD ON
OSSD ON
OSSD ON
www.abb.com/jokabsafety