GLOBBER EVO COMFORT PLAY Serie Manual Del Usaurio página 7

SCOOTER ASSEMBLY (See page 2)
EVO COMFORT is provided with an adjustable handlebar (T-bar) which can be
adapted to the child's height (4 positions). The spring-loaded ball shall be in the
hole when adjusting the T-bar height (see diagram E).
Make sure that for the lowest position of the T-bar the ball is locked into the lowest
hole (see diagram E). Loosen the quick release clamp of the handlebar (T-bar)
when adjusting. Tighten the quick release clamp to secure handlebar (T-bar) after
adjustment.
EVO COMFORT PLAY comes with a revolutionary light & sound LED module
directly integrated in the seat's handlebar, with different modes.
The different modes are: (Figure 6)
ON: Sound & LED lights activated
MUTE: Only LED lights activated
OFF: Both Sound & LED lights disabled
Activating the light & sound module on EVO COMFORT PLAY (Figure 5-6)
• Remove the module from the seat's handlebar by turning it anti-clockwise.
• Using the button, choose your preferred mode (MUTE or ON).
• Insert the module back into the seat's handlebar and turn clockwise to lock it.
It's advisable to switch the module OFF when not in use.
Charging the module (Figure 7)
EVO COMFORT PLAY light & sound module has an in-built rechargeable battery
which can be charged with a Micro USB cable at the back of the module. Use the
Micro USB cable provided in-pack.
Important notice for COMFORT PLAY MODULE
- Warning. Long cable. Strangulation hazard. Keep the USB cable out of children's
reach.
- A 3.7V rechargeable Lithium battery included is not replaceable.
- Micro USB cable is included in-pack.
- A USB plug charger respecting your country's voltage isn't included in-pack.
- Module is only to be charged by adults.
- Battery chargers used with the toy are to be regularly examined for damage to
the cord, plug, enclosure and other parts, and in the event of such damage, they
must not be used until the damage has been repaired.
- Toys liable to be cleaned with liquids are to be disconnected from the charger
before cleaning.
- Module must be inserted in the seat's handlebar before giving the toy to your
child.
Steering: EVO COMFORT's steering responds intuitively to the movement of the
body (see diagram B).
- When the child leans to the right, EVO COMFORT turns right!
- When the child leans to the left, EVO COMFORT turns left!
For the youngest children, on flat surfaces and in straight lines, EVO COMFORT
has a steering blocking system for better balance and to make learning easier.
- To lock, press the button above (see diagram C)
- To release, press the red button below (see diagram D)
During use:
- Standing on the scooter, one hand on each handle, push with one of your feet to
move forward. Proceed with caution at the start.
- Braking: a brake is located at the rear, when necessary press down on it to slow
down. Press down gradually in order to prevent skidding or loss of stability.
- Shoes are mandatory and we strongly advise you to wear trousers and long
sleeve shirts to avoid injury if you fall.
- Explain to the child clearly how to lock the scooter before any use.
Care / Maintenance:
Regular maintenance is a safety commitment:
- Wheel bearings: avoid going through water, oil or sand as this can damage
wheel bearings.
- Wheels: the wheels wear down with time and can be damaged if overly used
on rough surfaces. The back wheel on which the brake is applied is particularly
affected after several hours of braking. In the interests of safety, they should be
checked regularly and changed if necessary.
- Modifications: the original product must by no means be modified except for
the maintenance-related changes mentioned in these instructions.
- Nuts and axles: these should also be checked regularly. They can become
loose after a while in which case they should be tightened. They can become
worn and not tightened properly, in which case they should be replaced.
- Cleaning: Clean the scooter with a soft cloth and a little water.
7