Before You Begin - Brita WHS - 201 Instrucciones De Instalación

IMPORTANT NOTE:
This whole house filter system is designed to clean water and
reduce sediment. To improve the taste of water, consider
installing or using an undersink system, faucet mount, or
pitcher that is certified to improve the taste of water.
Please read all instructions, specifications, and precautions before
installing and using your water filter system.
Precautions: for cold water use only.
Consult your local plumbing codes and install accordingly.
This filter must be protected from freezing, which can cause cracking of the filter and water leakage.
Because of the product's limited service life and to prevent costly repairs or possible water damage, we strongly recommend that
the system be replaced every five years. If the head of the filter has been in use for longer than this period, it should be replaced
immediately. Date the top of any new head to indicate the next recommended replacement date.
Please wear safety glasses to protect eyes when drilling.
A grounding kit (not included) MUST be installed on water pipes if they are used to ground electrical systems, appliances,
or phones.
WARNING: Be sure that all electrical appliances and outlets adjacent to the filter installation are turned off at the circuit breaker before
beginning work.
• These filters are not water purifiers. Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• This unit is not designed to filter sulfur odor (rotten egg odor) caused by hydrogen sulfide. Use of carbon filters to treat sulfur odor
may intensify taste/odor problems.
• Please comply with all state and local regulations regarding the installation of water treatment devices.
• The contaminants or other substances reduced by the water filter device are not necessarily in your water.
• After prolonged periods of non-use (such as during a vacation), it is recommended to thoroughly flush the system. Let water run for
10 minutes before using.
• The filter cartridges used with this system have a limited service life. Changes in taste, odor, and/or flow of the water being filtered
indicate that the cartridge should be replaced.
• Your water filtration system will withstand up to 100 psi water pressure. If your house water supply pressure is higher than 100 psi,
install a pressure reducing valve before the system is installed.
These units are intended for non-commercial use. They should be used only in ambient air temperature of between 40 degrees F /
4.4 degrees C and 100 degrees F / 37.7 degrees C. Placement of these units in direct sunlight or use of electrical heating equipment
on these units must be avoided. Replace filter cartridge when and as directed in the installation / operation instructions included with
each cartridge. Replacement filter cartridges are available at retail outlets.
WHS-201 installation instructions
NOTICE
!
CAUTION
WARNING
Filtration Facts
Operation / Maintenance Data

Before You Begin

Version 2.0D
3