Programming Stan- Dard Doses - Nuova Simonelli Appia Manual Del Usario

7.5
PROGRAMMING STAN-
DARD DOSES
• It is possible to enter pre-set values for the
4 group doses and water (steam).
To do this, it is necessary to press the key
and hold it down for at least 10
seconds until the flashing keys switch off.
The doses are:
1CN 2CN 1CL
40 cc 60 cc 50 cc
WATER
9 sec.
NOTE: A time setting of 0 seconds for steam
and water means this function will work
continually.
7.6
COPYING DOSE SET-
TINGS
It is possible to copy the dose settings for
group 1 to groups 2 or 3.
To do this, hold down the continuous key
of the group 2 or 3 for at least 8
seconds until the keys stop flashing.
7.7
PROGRAMMING OPE-
RATING PARAMETERS
The adjustments listed here below must
ONLY be performed by a Specialist
Technical Engineer
If you hold down the
second group, after first entering the program-
2CL
ming mode for the first group, this will access
85 cc the machine parameters setting mode; this is
signalled by the continuous key
the second group, which will switch on.
.
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the
dose programming function.
3. Adjusting keypad brightness.
4. Enabling the hot water pump (on machi-
nes fitted with economiser).
5. Disenabling the cup warmer
6. Restoring default settings.
1. Enabling the pump during levelling.
Use the espresso key
enabling during levelling:
if the key
together with the level; if it is switched off, the
pump is not enabled with the level function.
2. Enabling the software block to enter the
Use the long coffee key
CAUTION software block to programme doses (key lit) or
to de-activate the block (key off).
3. Adjusting keypad brightness..
The 2 long coffees key
group is used to choose the key brightness set-
key of the
ting from 5 pre-set levels.
Use the
for
change the level, lowering it to minimum or
returning it to maximum.
4. Enabling the hot water pump (machines
Use the hot water key
to switch on while hot water is being delivered.
If the
while hot water is being delivered; if it is swit-
ched off, the pump will not switch on.
5. Disenabling the cup warmer..
Use the
to set pump
cup warmer operation. If the key is lit, the cup
warmer will operate normally as set during pro-
is lit, the pump is enabled
gramming; if the key is switched off, the cup
warmer is disenabled.
dose programming function.
of the second
key, which will flash, to
fitted with economiser only).
to set the pump
key is lit, the pump will switch on
key to enable or disenable
to enable a
39