Sirius SLT960 Instrucciones De Uso Y De Montaje página 12

WARNINGS
The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with
the appliance.
The air sucked can't be conveyed throu-
gh or into a duct used to let out fumes
from appliances fed by energy other than
electric power (eg. centralized heating, ra-
diators, water-heaters, etc.).
To evacuate the air outlet, please comply
with the pertaining rules given by compe-
tent authorities.
Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas-, oil-,
or coal- stoves, etc.) are used simultaneou-
sly. The cooker hood, when evacuating the
sucked air, could generate a negative pres-
sure in the room- which can't exceed the li-
mit of 0.04 mbar, in order to avoid the suck
of exhausts deriving from the heat-source.
Therefore the room should be provided with
air-intakes to allow a costant flow of fresh air.
If the rating lable in the cooker-hood does
not show the symbol
built in class I° and it needs the earth con-
nection.
When performing the electrical connections
on the appliance, please make sure that the
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the label placed inside the ap-
pliance itself.
Before carrying out any cleaning or maintai-
ning operations, the appliance needs to be
removed from the electric grid.
If the appliance is not provided with a non-
separable flexible cable and plug, or with
another device ensuring omnipolar discon-
nections from the grid, with an opening di-
stance between the contacts of at least 3 mm,
then such disconnecting devices must be
supplied within the fixed installation.
, the appliance is
12
If the appliance is endowed with a supply cord
and a plug, the appliance has to be put in a
place where the plug can be reached easily.
The use of materials which can burst into
flames should be avoided in close proxi-
mity of the appliance. When frying, please
pay particular attention to fire risk due to
oil grease. Being highly inflammable, fried
oil is especially dangerous. Do not use un-
covered electric grills. In order to avoid
possible fire risk, all instructions for grea-
se-filter cleaning and for removing even-
tual grease deposits should be strictly fol-
lowed.
USES
PANELS OPENING
The grease filters cover panels are opened by
slightly pulling them , as shown in fig. 1.
Open the glass panels using both hands and
take them up to full opening.
CONTINUE TO TAKE THE GLASSES UP WHI-
LE OPENING THEM.
BEFORE INSTALLATION , IN ORDER TO AVOID
ANY POSSIBLE DAMAGE TO THE GLASSES ,
WE RECOMMEND TO REMOVE THEM BY UN-
SCREWING THE EIGHT SCREWS SHOWN IN
FIG.18. ELECTRICALLY DISCONNECT THE LED
BARS , BY USING THE SPECIFIC BIPOLAR AC-
TUATOR , AND REFIT THE GLASSES AND THE
ELECTRIC WIRING ONCE INSTALLATION IS
COMPLETED.
THE APPLIANCE CAN BE INSTALLED IN
BOTH BUILT-IN
VERSION.
For proper operation, we recommend to in-
stall the appliance at a maximum distance of
2000 - 2100 mm from the floor.
Before installing the appliance, check that all
the components are not damaged, otherwise
contact your retailer and do not carry out in-
stallation.
Use an air exhaust pipe , whose length does
not exceed 5 meters.
- Limit the number of elbows , since each
elbow reduces the appliance air capacity of
about 1 linear meter . (E.g.: if no. 2 x 90°
elbows are used , the piping length shall not
AND FREE-STANDING