Manual Storing Of Station Presets - Alpine 3DE-7887R Manual De Operación

1
PTY
M. I. X.
30
1 2 3
NEWS MONO
4 5 6
RPT SCAN
Radio Operation
Manual Storing of Station
Presets
1. Tune in the desired radio station you wish
to store in the preset memory.
2. Press and hold any one of the preset
buttons (1 through 6) for at least 2
seconds. The frequency display will begin
to blink.
3. Press the preset button into which you wish
to store the station while the display is
blinking (within 5 seconds).
The display stops blinking once the station
has been memorized. The display shows
the band, preset No. with a triangle (9)
and station frequency memorized.
4. Repeat the procedure to store 5 other
stations onto the same band.
To use this procedure for other bands,
simply select the band desired and follow
steps 1 – 3 above.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
MW and LW).
Note: If you store a station in a preset memory
which already has a station, the current
station will be cleared and replaced with
the new station.
English