Kit Assembly - Metra 99-7360B Instrucciones De Instalación

1. Secure the radio brackets to the pocket
using the (2) #8 x 3/8" Phillips screws
provided. (Figure A)
Note: Pins on brackets will align with
front mounting hole of pocket.
2. Slide the radio into the bracket/pocket
assembly, then secure it using the screws
supplied with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
4. Secure the radio assembly to the dash
using the factory screws.
5. Clip the 99-7360B radio trim panel over
the radio assembly, then reassemble the
dash in reverse order of disassembly to
complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B)
3
REV. 5/24/2018 INST99-7360B