Checking The Battery Health; Replacing The Sliding Washers; Exchanging Components Of The Cover Plate; Cleaning - FIOR & GENTZ NEURO TRONIC Manual De Instrucciones

For detailed information on the activity level, refer to the orthotic treatment sheet, our Orthosis Con-
figurator at www.orthosis-configurator.com or our online tutorials at www.fior-gentz.com.
Secure the screws for the cover plate with the torque corresponding to the system width and LOCTITE® 243
medium strength at every maintenance (see paragraph 9.6). Remove all adhesive residues first.

13.1 Checking the Battery Health

If the orthosis is equipped with a controller with integrated lithium-polymer battery, check the battery health
regularly (see manual Multi-Purpose Device). To do so, connect the controller with the multi-purpose device/
Expert app. If the battery health is no longer good, replace the controller on the orthosis.

13.2 Replacing the Sliding Washers

Sliding washers are available in different thicknesses (e.g. GS1407-040 is 0.40mm thick). Each thickness has
a different marking (fig. 32). You will find the article numbers of the premounted sliding washers on the back
page of this manual.
0.40mm

13.3 Exchanging Components of the Cover Plate

If one component of the cover plate wears out, it has to be exchanged for a new one.
To mount the cover plate again, proceed as follows (fig. 33):
1 Place the sliding washer (1) onto the lever (2).
2 Slide the lever into the hole in the cover plate (3).
3 Slide the ball (4) and the pressure spring (5) into the lever.
4 Press the switching pawl (6) onto the lever from behind.
5 Secure the sub-assembly with the retaining washer for shafts (7) on
the cover plate.

13.4 Cleaning

The system joint must be cleaned when necessary and during regular
maintenance. For this purpose, disassemble the system joint and clean the
soiled system components with a dry cloth.
36
0.45mm 0.50mm 0.55mm 0.60mm
7 6 5
4
fig. 32
3
1
2
fig. 33