Power Supply; Operation - Zodiac VORTEX 3 Instrucciones De Montaje Y De Uso

2-Notice CO ANG.qxd 13/09/10
It is imperative that the cleaner sinks to the bottom and comes to rest
without intervention from you. Spread the cable out over the pool.
For optimum operation we recommend that you place the caddy with
the control box midway down the length of the pool.

3.4. POWER SUPPLY

Diagram 6
VERY IMPORTANT! If you use an extension cable to connect your cleaner to the
power supply, ensure the control box is placed no less than 3.5 meters from the
pool edge.

3.5. OPERATION

3.5.1. Description of keys and indicator diodes
Programme I: Maximised cleaning of the pool floor in minimum time. Duration 1 h r 30.
Programme II: Intense cleaning of the pool floor and the pool sides, including the waterline.
Duration 2 hrs 30.
OFF button: used to cut the cleaner power supply at the end of a cleaning cycle.
APPLIES FOR VORTEX
Decreases cleaning time by 30 min. Increases cleaning time by 1 hr.
3.5.2. Start-up
Diagram 7
is operating. Just press the key corresponding to the other programme (I or II). A complete new
cleaning cycle will start.
9:12 Page 17
For your safety and for correct cleaner operation proceed in the following
manner:
•
Place the control box at a distance of at least 3.5 meters from the pool edge
and away from direct sunlight; it can either be placed on the ground or
attached to the caddy.
•
Connect the cleaner cable to the control box
the connector by firmly tightening the ring by turning it clockwise. Make sure the
connector is sufficiently pushed into place, if this is not the case repeat
operation (6-2).
•
Connect the power cable. Only connect the control box to a power outlet
protected by a 30 mA maximum ground fault circuit breaker
(if in doubt contact a qualified electrician).
TM 4 ONLY:
When the cleaner is powered on the control box it remains in standby until a
start command is given.
The cleaner is started by pressing the key corresponding to one of the 2 clea-
ning programmes (Diagram
gramme will light up.
The cleaner starts after a few seconds and calculates its own trajectory.
You can change the selected cleaning programme at any time when the cleaner
(Diagram 6-1 &
7). The indicator located above the selected pro-
17
Diagram 5
6-2) and lock