Cleaning And Storing The Cleaner; Replacing The Brushes - Zodiac VORTEX 3 Instrucciones De Montaje Y De Uso

2-Notice CO ANG.qxd 13/09/10
•
Remove the filter from its holder (11-6).
•
Empty the filter and clean it using running water
•
Rinse the filter holder and remove any debris stuck inside it.
•
Fit the filter onto its holder and replace in the cleaner.
•
Close the cover and make sure that it is locked.

4.2. CLEANING AND STORING THE CLEANER

The cleaner must be cleaned regularly using slightly soapy clean water, do not use
solvents such a trichloroethylene or its equivalent.
Rinse the cleaner generously using clean water. Do not let your cleaner dry in direct
sunlight near the pool.
The cleaner must be stored on its own caddy, so that it dries quickly.
Diagram 12
REMINDER: The cleaner cable must be disconnected from the control box before removing the
cleaner from the pool. Wrap the cleaner cable around the hooks located at the rear of the caddy
starting from the cleaner.
The cleaner is fitted with PVC brushes. There are ''wear'' indicators on the
brushes. To maintain cleaner performance at its best you need to replace
the brushes as soon as one of the wear indicators has been reached (even
if the blade wear is not even).
We recommend that you replace the brushes every two seasons.
To remove worn brushes, remove the tabs from the holes in which they
are fitted
To fit new brushes start by fitting the side without tabs under the brush holder
Roll the brush around its holder and slide the tabs into the fixing holes. Pull on the end of each
tab (14-2) so that its edge passes through the slit. Cut the tabs using scissors so that they are
at the same level as the other blades. Repeat this operation with the second brush.
Diagram 14
9:12 Page 21

5 / REPLACING THE BRUSHES

(Diagram 13).
(Diagram 11-7).
Place the rear wheels on the blocking
wedges (Diagram
Tip the appliance so that it rolls natu-
rally to its storage position (12-2).
21
Diagram 11
12-1).
Diagram 13
14-1).
(Diagram