Descaling; Cleaning Function; Procedure; Descaling The Appliance - Boneco U700 Manual Del Usaurio

18

DESCALING

en

CLEANING FUNCTION

The BONECO U700 is equipped with a descaling function.
All you need is a packet of "BONECO EZCal". One of these
packets is included with the appliance. You can obtain
more EZCal bags from your BONECO specialist dealer or
our online store at www.boneco.us.
The BONECO U700 uses this symbol to indicate that des-
caling is needed:

PROCEDURE

During descaling, the water is heated by the heater for 5
minutes and then pauses for 25 minutes each time. This
process repeats until the cleaning time has elapsed. The
cleaning time can be set between 1 and 4 hours. As a rule:
The longer the cleaning process, the better the results.

DESCALING THE APPLIANCE

1. Switch off the BONECO U700.
2. Empty the water base and the water tank.
3. Remove the HydroCell and the demineralization
cartridge from the water-tank.
4. Mix 1 packet of EZCal with 1 liter (a quarter gallon) of
water and pour the mixture into the water tank.
5. Place the water tank back onto the base of the unit.
6. Press the symbol for 3 seconds. Descaling starts.
7. Tap the symbol repeatedly to set the desired clean-
ing time. The cleaning time increases by one-hour
increments (max. 4 hours).
The symbol for the cleaning mode flashes on the display.
The BONECO U700 switches off automatically once the
cleaning time has elapsed.
8. Empty the water base and fill the water tank with tap
water.
The cleaning symbol goes out. The BONECO U700 is
ready for use again.

REMOVING LIMESCALE RESIDUE

Stubborn limescale residue on the membrane can be re-
moved using the yellow brush stored inside the BONECO
U700.
Never clean the membrane using sharp objects or
aggressive cleaning agents; doing so can damage
the BONECO U700 and voids the warranty!