ProMinent DULCOTEST CLB1-mA-10ppm Instrucciones De Montaje Y Funcionamiento página 41

Electrical installation
1. Turn the sensor adapter a quarter run in
an anticlockwise direction and remove
(bayonet fitting)
2. Loosen the clamping screw on the con‐
nection and pass through the measuring
line from the control device
Fig. 3: 2-lead connection
3. Strip the ends of the cables and connect
to the 2-lead connection: 1 = plus, 2 =
minus
4. Bring approx. 5 cm of the measuring
wire into the sensor and tighten the
clamping screw on the connection
5. Push the sensor adapter fully into the
housing and turn it carefully in a clock‐
wise direction until it can go no further,
ensuring that the nibs of the bayonet
fixing do not break off
A0102
Installation
41