General Safety Information - ProMinent DULCOTEST CLB1-mA-10ppm Instrucciones De Montaje Y Funcionamiento

A technical expert is deemed to be a
n
person who is able to assess the tasks
assigned to him and recognise possible
hazards based on his/her technical training
and experience, as well as knowledge of
pertinent regulations.
Note: A technical qualification is typically
proven by the required completion of a
technical training course. The assessment
of a person's technical training can also be
based on several years of work in the rele‐
vant field.
A qualified employee is deemed to be a
n
person who is able to assess the tasks
assigned to him and recognise possible
hazards based on his/her technical
training, knowledge and experience, as
well as knowledge of pertinent regulations.
Note: The assessment of a person's tech‐
nical training can also be based on several
years of work in the relevant field.
An instructed person is deemed to be a
n
person who has been instructed and, if
required, trained in the tasks assigned to
him/her and possible dangers that could
result from improper behaviour, as well as
having been instructed in the required pro‐
tective equipment and protective meas‐
ures.
Customer service department refers to
n
service technicians, who have received
proven training and have been authorised
by ProMinent to work on the system.
Note for the system operator
The pertinent accident prevention regula‐
tions, as well as all other generally
acknowledged safety regulations, must be
adhered to!
1.3

General Safety Information

WARNING!
Unauthorised access!
Possible consequence: Fatal or very
serious injuries
– Measure: Ensure that there can be no
unauthorised access to the unit
– The sensor may only be fitted,
installed, serviced and operated by
personnel trained for this
CAUTION!
Functional limitations
Possible consequence: Slight or minor
injuries, material damage
– Check the sensor regularly for dirt
and impurities
– Check the membrane cap regularly
for air bubbles adhering to it
– Observe all applicable national regu‐
lations relating to maintenance,
service and calibration intervals.
Introduction
33