Stanley SS30 Manual De Instrucciones página 18

ENGLISH (
Original Instructions)
LABELS ON TOOL
The following symbols are shown on the tool along with date
code:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear ear protection.
Wear safety glasses or goggles.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of Date Code (FIG. A)
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2018 XX XX
Year of manufacturing
PACKAGE CONTENTS
The package contains:
1 Random orbit sander
1 Sanding paper
1 Dust bag
1 Instruction manual
1 Warranty card
1 Service center list
♦ Check for damage to the tool, parts or accessories
which may have occurred during transport.
♦ Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (FIG. A)
WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
This tool includes some or all of the following features.
1. On/off switch
2. Electric speed control dial
3. Dust bag
4. Dust bag collar
5. Dust extraction outlet
6. Sanding pad
7. Sanding paper
18
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min. Reciprocation per
minute
ASSEMBLY
WARNING! Before assembly, make sure that the tool is
switched off and unplugged.
WARNING! To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source
before making any adjustments or removing/installing
attachments or accessories. Before reconnecting the tool,
depress and release the trigger switch to ensure that the
tool is off. An accidental start-up can cause injury.
Fitting sanding paper (Fig. B)
Warning! Never use the tool without a sanding
paper or accessory in place. The tool uses 125 mm
(5") hook and loop sanding paper with an 8 hole
dust extraction pattern.
1. Place the tool on a table, sanding pad (6) up
2. Place the sanding paper (7) directly on top of the
sanding pad
3. Hold the sanding pad with one hand and align the dust
extraction holes.
4. Press the sanding paper firmly onto the sanding pad.
Setting the Electronic Speed Control Dial
(Fig. A)
The speed is infinitely variable from 0–13,000 min-
the electronic speed control dial (2)
Turn the electronic speed control dial to the required level.
The correct setting, however, is a matter of experience.
Generally, harder materials require a higher setting.
Dust Extraction (Fig. C)
WARNING! Since woodworking with a sander
produces dust, always install a dust bag designed in
compliance with the applicable directives regarding
dust emission
WARNING! Do not use a dust bag or vacuum
extractor without proper spark protection when
sanding metal.
Your sander has a dust extraction methods: a built-in outlet
(5) which allows either the supplied dust bag (3) or a shop
vacuum system to be connected.
TO ATTACH THE DUST BAG
1. While holding the sander, fit the dust bag collar(4) to the
outlet (5) as shown in Fig. C.
2. Turn the collar (4) anticlockwise to lock the dust bag
(3) in place.
TO EMPTY THE DUST BAG
Note: Be sure to wear approved eye protection and
approved dust mask when performing this procedure.
For efficient dust extraction, empty the dust collector
when it is about one third full.
1. While holding the sander, turn the collar (4) clockwise to
unlock the dust bag (3).
2. Remove dust bag from the sander and gently shake or
tap the dust bag to empty.
using
1