Automatic Startup Process - HP mfp analog fax Guía Del Fax

Automatic startup process

Note
ENWW
The first time the device is connected to an mfp, it may take up to 5
minutes to complete initialization. The following boot sequence can be
observed:
All LEDs light momentarily: Power applied to Fax device
LED blinks slowly: Parallel interface initialization
LED blinks quickly: PCMCIA interface initialization
LED on steady: Ready state
Wait for this automatic boot process to complete before continuing.
LED blinks constantly when COUNTRY/REGION is not configured. The
COUNTRY/REGION setting is configured in "Specifying the fax settings"
on page 15.
Automatic startup process 11