Electronic Board - VALPES POSI P8 Manual De Instalación Y Funcionamiento

Index

Electronic board ......................................................................................................................... 6

LED meaning .............................................................................................................................. 7
Electric diagram ......................................................................................................................... 8
Electric connections ................................................................................................................... 9
Learning procedure .................................................................................................................... 9
Description
The P8 option is a 4-20 mA or 0-10 V analogue signal positioning solution with position feedback capability.
0-10 V: In case of outside event, absence of control signal (accidental wires cut for example) but in the presence of power,
the actuator will travel to defined position (open or closed valve). As standard our actuators will close themselves with absence
of control signal but there are other possibilities on request.
4-20 mA: In case of outside event, absence of setpoint signal (accidental wires cut for example) but in presence of power, the
actuator will stay in its position.
X
Thanks to A MART ®
(via Bluetooth
programming, to control it locally and to set it up.
For any further information, refer to the operation manual DSBA3304.
Electronic board
Actuator voltage
Charging status feedback relay (65/66)
Failure feedback relay (67/68)
6
connection), it's possible to check all parameters of the actuator, to access the weekly
®
100 V to 240 V AC 50/60 Hz and 100 V to 350 V DC
24 V to 30 V AC 50/60 Hz and 24 V to 48 V DC
24 V DC - 1 A max
24 V DC - 3 A max
EN
DSBA3307 • Rév. 16/04/2021