KPF-01
Power harmonic clamp meter
Battery-low Indication
If battery voltage is low,
corner of LCD. Then, it is needed to replace new batteries.
Battery Replace
Warning
Before opening the back lid to replace batteries, please make sure the
meter is turned off and no test probe is connected to any test wire so as
to avoid electrical shock; before using the meter, please make sure the
back lid is tightly closed. Only batteries of identical model or electrical
specification can be used.
1. If
symbol is shown on LCD, it signifies that battery voltage with load
is lower than the minimum voltage for ensuring measurement error limits,
and the meter will prompt you to change new batteries. Please follow the
steps below to replace batteries:
2. Disconnect test probes from test circuit, and rotate function-switching
knob to "OFF", and then take off test probes from the input sockets.
3. Open battery cove, Take out old batteries, and replace them with 3 new
1.5 V batteries. New batteries shall not be used together with old ones.
Properly close the battery cover.
Instructions manual |
30
symbol will be displayed on the upper right
www.grupotemper.com