Tabla de contenido
Publicidad
Instructions de sécurité (suite)
Étiquettes d'avertissement
Trouver et lire toutes les étiquettes
d'avertissement qui se trouvent sur le
compresseur d'air indiquées plus bas
Fr 6
TROUBLE
Excessive belt wear
Oil in the discharge
air
DK724100AV 1000
PROBABLE CAUSE
1. Pulley out of alignment
1. Realign motor pulley with
compressor pulley
2. Belt too loose or too tight
2. Adjust tension (See Drive
Belt Section)
3. Belt slipping
3. Adjust tension or replace
belt (See Drive Belt
Section)
4. Pulley wobbles
4. Check for worn crankshaft,
keyway or pulley bore
resulting from running the
compressor or motor with
loose pulleys. Check for
bent pulleys or bent crank-
shaft
1. Worn piston rings
1. Replace with new rings
2. Compressor air intake
2. Clean filter. Check for other
restricted
restrictions in the intake
system
3. Restricted breather
3. Clean and check breather
for free operation
4. Excessive oil in compres-
4. Drain down to full level
sor
5. Wrong oil viscosity
5. Use SAE 30 (ISO 100)
non-detergent compressor
oil, Mobil 1 5W30 or Mobil
1 10W30 (See page 14).
6. Connecting rod out of
6. Replace rod
alignment
23
REMEDY
Publicidad
Tabla de contenido
