Powered Pet Hair Cleaning Tool; Agitator Brush Roll; Agitator Brush Roll Belt - Hoover WindTunnel 2 El Manual Del Propietario

Grasp agitator brush roll firmly
45
and fit it into position by first slid-
ing end opposite the belt into the rectan-
gular slot (F) on side of the cleaner.
Pull other side of agitator brush roll into
place.
Turn agitator brush roll making sure belt
is not pinched between agitator brush
roll and agitator brush roll shield.

Powered pet hair cleaning tool

Agitator brush roll

When agitator brush roll brushes on
the powered pet hair cleaning tool
are worn, the agitator brush roll should
be replaced. Ask for HOOVER part
No. 48414088.
How to replace
1. Remove tool from hose and
47
turn it so bottom faces up. Press
the latches on either side of tool and
remove bottom plate (A).
14
F
Reposition bottom plate and five
46
screws. Tighten screws securely.
2. Unscrew the two Phillips
48
A
screws and remove belt guard
(B).

Agitator brush roll belt

The agitator brush roll belt is designed to
B
last the lifetime of the cleaner. It typical-
ly should not need replacement. If you
feel the agitator brush roll belt needs to
be checked or replaced, take your
cleaner to an Authorized Hoover
Sales and Service Center. Do not
attempt to remove the agitator brush
roll belt.
B
49
discard.
4. Inspect belt to ensure that it is in
good condition. If belt is cracked,
gouged or broken, replace it (see fol-
lowing section).
C
3. Remove agitator brush roll
including end plates (C) and