Troubleshooting - Silverline 261345 Traducción Del Manual Original

GB

Troubleshooting

Problem Possible cause Solution
No power Check power supply
No function when On/Off Switch
(4) is operated
Have the On/Off Switch replaced by an authorised
Defective On/Off Switch
Silverline service centre
Slow material removal Sanding sheet too fine or worn Fit new sanding sheet with coarser grit
Sanding sheet too coarse Fit new sanding sheet with finer grit
Scratches on workpiece
after sanding
Not enough material removed Continue sanding
Sanding sheet incompatible with material Fit correct sanding sheet
Burn marks on workpiece
Too much pressure exerted on to the sander Use less pressure whilst moving the machine
Vacuum dust extraction system not connected, or Check connection of the vacuum hose, and
extraction system not switched on ensure dust extraction system is switched on
Excessive dust emission
Dust extraction not working; sanding sheet not
aligned with dust extraction holes in the Sanding Realign sanding sheet; unblock dust extraction holes
Base; extraction holes blocked
8