Heat Appliance While Empty; Insert Accessories - Medion MD 11711 Manual Del Usuario

Heat appliance while empty

Before using the microwave you must first heat it up whilst empty in order
to remove remains left over from production. To do this, switch the device
on in the Grill operational mode, without food and without accessories, as
described in the following:
•
Open the door and remove packaging or accessory parts from the
interior, if necessary. Then close the door again.
•
Press the A ir e c al ie n te button once. You will select the hot air
operation with this. A temperature of 230°C will appear in the display.
•
Turn the
•
The device will switch off automatically after the process has finished.
Note:
During this initial heating period you may notice faint odours. The odour will
disappear after a short period of time. Ensure adequate ventilation e. g. by
opening a window.
•
After 10 minutes the appliance turns itself off automatically. Wait until
it has completely cooled down.
•
Remove the plug from the socket and then clean the appliance once
more inside and out with a damp cloth and dry it off carefully.

Insert accessories

When you have heated the microwave once empty as stated above it may
no longer be used without the roller ring and rotating plate inserted
properly.
•
Insert the roller ring in the centre of the cooking area over the drive
axle.
•
Set the rotating plate over the centre of the roller ring.
14
control clockwise, to set a cooking time of 10 minutes.