Electrical Connection - Sime AR Serie Manual De Instrucciones

plied, then refit the burner plate.
– Place de glass fibre (1) around the
boiler body.
– Mount the left (4) and right (5) sides
introducing the slot of the rear fold
between the two nuts on the tie-rods.
– Secure the sides to the front panel
(3) by means of the pins.
– Secure the two rear panels (6) and
(7) to the sides with the ten tapping
screws supplied.
– Secure the front panel (8) to the
sides by means of the pins.
– Mount the contr ol panel (9) by
means of the pins.
Prior to performing the above ope-
ration, unwind the capillary tubes of
the two thermostats and of the
t her mome t er by inser ting t he
respective probes in the holder (11),
then lock with the spring supplied.
It is recommended to complete all
electrical connections as shown in
the paragraph 2.6.
– Complete assembly by securing the
cover (10) to the sides.
NOTE: Remove the "Testing Certifica-
t e" fr om inside the combustion
chamber and keep together with the
instructions manual.
2.6

ELECTRICAL CONNECTION

The boiler is fitted with an electricity
cable, and requires a a single-phase
power supply of 230V - 50Hz through
8
KEY
TS H.L. stat
TA Room stat (*)
TC Boiler stat
IG Main switch
the main switch protected by fuses.
The room thermostat (required for
enhanced room temperature control)
should be installed as shown in fig. 4.
Connect the burner power cables
PI C.H. pump (*)
B Burner (*)
SB Burner lock-out lamp
(*) Not supplied
supplied.
NOTE: SIME declines all responsibi-
lity for injury caused to persons due
to failure to earth the boiler.
Fig. 4