Information Only For Authorised Assistance Centres - Dalla Corte mini Manual De Usuario

information only for authorised
assistance centres
coffee group temperature regulation
The installed electronic central control unit has got a temperature
which can be regulated between 85°C and 110°C.
In order to set the temperature of the coffee group, follow these
instructions:
In order to raise the temperature of the group, turn the regulation
knob (pic. 3) clockwise, in order to decrease it turn it anticlock-
wise (the regulation knob can turn by ¾ of the rev to reach the
maximum range in the regulation between 85°C and 110°C)
how to program the coffee doses
The coffee doses are programmed in the following way:
• Keep on pressing the button P3 of the keyboard until all the three leds light up (about 30")
• Prepare the filterholder and press the button P1 (coffee supply starts), when You get the quantity
you want, press the button P3 to stop (the led of the button P1 switches off).
• Repeat the procedure pressing the button P2 (coffee supply starts), when You get the quantity you
want, press the button P3 to stop (only the led of the of the button P3 stays on).
• In order to record the doses and finish the procedure, press again the button P3
(the corresponding led switches off too).
how to program the pre-infusion time
It is possible to regulate the pre-infusion time as follows:
While you keep on pressing the button P1, turn on the machine; the led of button P1 will lighten, turn
off the machine and turn it on again, in this way you have set the pre-infusion time at 4 s.
If You prefer a shorter time (2 s), perform the same operation but press the button P2 instead of P1,
the led of button P2 will then lighten up.
In order to cancel the pre-infusion time completely, follow the procedure described here above but
press button P3 when you turn on the machine; the corresponding led will lighten up, then switch off
and on again the machine.