Setting Up For Installation - Dalla Corte DC PRO Manual De Usuario

Setting up for installation

Place the machine on a surface
that guarantees a secure support.
To get ready for set up, make sure
you have an opening of at least
10x10 cm on the support surface (A
Pic. 1) to allow connection with sys-
tems in the space below (B Pic. 1).
The machine should be connec-
ted to an appropriate drinking
water source compliant with
national laws.
The incoming water pressure
should be between 0.1 and 0.6
MPa. If such requirement is not
met, please consult the manu-
facturer.
A tap must be installed between
water system and machine water
hose in order to be able to stop
water flow if necessary (1 Pic.1).
38
Connect a 40 mm diameter drain
siphon (5 Pic.1) with the local
drain system (4 Pic.1).
The machine is not equipped
with any plug since it is desig-
ned to be connected directly to
the electrical system – an om-
nipolar switch compliant with
national laws must therefore be
installed (7 Pic.1).