Removing And Installing Lower Plate - Panasonic Quickdraw MC-UG502 Instrucciones De Operación

WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Three Screws
Trois vis
Tres tornillos
Lower Plate
Plaque inférieure
Base inferior
Electrical Shock or Personal Injury Hazard

Removing and Installing Lower Plate

➢ ➢ Before servicing any parts,
disconnect vacuum cleaner from
electrical outlet.
➢ ➢ Place paper under nozzle anytime
lower plate is removed to protect
floor.
➢ ➢ Place handle in upright position and
turn vacuum cleaner over to expose
lower plate.
➢ ➢ Release lower plate by removing
three (3) screws.
➢ ➢ Remove lower plate and remove any
residue that may exist in belt area.
➢ ➢ Reinstall lower plate by hooking front
end of lower plate into slots on front
of nozzle housing.
Make sure all wires are routed
➢ ➢
properly and not pinched.
➢ ➢ Press lower plate into place then
replace three (3) screws.
- 28 -