Connecting The Water Line; Before Beginning; Water Pressure - LG GS73SXS Manual Del Propietário

Assembling the Refrigerator Door
1 Place the door onto the lower hinge pin.
Lower Hinge
2 Fit the upper hinge over the hinge lever latch and
into place. Rotate the lever counterclockwise to
secure the hinge.
(2)
3
Reconnect all wire harnesses. Hook the tab on
the switch side of the cover under the edge of the
wire opening in the cabinet top. Position the cover
and replace the screw.

Connecting the Water Line

Before Beginning

This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
,I QHFHVVDU\ FDOO D TXDOL¿HG SOXPEHU WR FRUUHFW ZDWHU
hammer before installing the water supply line to
the refrigerator. Water banging in the pipes, or water
hammer in residential plumbing can cause damage
to refrigerator parts and lead to water leakage or
ÀRRGLQJ
x Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
x Do not install the icemaker tubing in areas where
(1)
the ambient temperatures fall below freezing.
x Connect to a potable water supply only.
x To prevent burns and product damage, only
x Wear eye protection during installation toprevent

Water Pressure

You will need a cold water supply.
PRGHOV ZLWK ZDWHU ¿OWHU
where reverse osmosis
ZDWHU ¿OWUDWLRQ V\VWHP LV
connected to a cold water
supply
WARNING
CAUTION
connect the refrigerator water line to a cold water
supply.
injury.
Water Pressure
20–120 psi
(138 - 827 kPa)
40–60 psi minimum to
reverse osmosis system
(2.8 kgf/cm
cm
VHFRQGV WR ¿OO D FXS RI 
oz capacity)
INSTALLATION 17
2 – 4.2 kgf/
2
,or less than 2–3