LG GS73SXS Manual Del Propietário página 19

3
Drill the hole for the valve.
x Drill a ¼ in. hole in the water pipe using a sharp
bit. Remove any burrs resulting from drilling the
hole in the pipe. Be careful not to allow water
to drain into the drill. Failure to drill a ¼ in. hole
may result in reduced ice production or smaller
cubes.
NOTE
x The hookup line cannot be white, plastic tubing.
Licensed plumbers must use only copper tubing
(NDA tubing #49595 or #49599) or Cross Link
Polyethylene (PEX) tubing.
4 Fasten the shutoff valve.
Fasten the shutoff valve to the cold water pipe
with the pipe clamp.
Pipe Clamp
Saddle-Type
Shutoff Valve
NOTE
x Commonwealth of Massachusetts Plumbing Codes
248CMR shall be adhered to. Saddle valves are
illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.
5
Tighten the pipe clamp.
Tighten the clamp screws until the sealing washer
begins to swell.
Pipe Clamp
Clamp Screw
NOTE
x Do not over tighten clamp or you may crush the
tubing.
Vertical Cold
Water Pipe
Inlet End
Washer
6
Route the tubing.
Route the tubing between the cold water line and
the refrigerator.
Route the tubing through a hole drilled in the wall
RU ÀRRU EHKLQG WKH UHIULJHUDWRU RU DGMDFHQW EDVH
cabinet) as close to the wall as possible.
NOTE
x %H VXUH WKHUH LV VXI¿FLHQW H[WUD WXELQJ DERXW  IW
coiled into three turns of about 10 in. diameter) to
allow the refrigerator to move out from the wall after
installation.
7
Connect the tubing to the valve.
Place the compression nut and ferrule (sleeve)
for copper tubing onto the end of the tubing and
connect it to the shutoff valve.
Make sure the tubing is fully inserted into the
valve. Tighten the compression nut securely.
Saddle-Type
Shutoff Valve
Packing Nut
Outlet Valve
8
Flush out the tubing.
7XUQ WKH PDLQ ZDWHU VXSSO\ RQ DQG ÀXVK RXW WKH
tubing until the water is clear. Shut the water off at
the water valve after about one quart of water has
EHHQ ÀXVKHG WKURXJK WKH WXELQJ
INSTALLATION 19
Compression
Nut
Ferrule
(sleeve)