Rohm CAPTIS-M Traducción De Las Instrucciones De Servicio Originales página 88

Inserting the collet chuck
Condition:
■ The collet chuck CAPTIS-M is in release position.
4. Press the grip of the interchanger (1).
 The grip must perceptibly lock into place.
5. Insert the collet chuck into the collet chuck CAPTIS-M in the correct
position until the coupling area of the collet chuck is behind the coupling
of the collet chuck CAPTIS-M.
6. Press the grip key of the interchanger (1) to unlock the collet chuck (2).
7. Remove the interchanger (1).
122017 / 1.0
1
2
1. Clean the mating surfaces of the
collet chuck CAPTIS-M and of
the collet chuck (2).
2. Place the collet chuck (2) on
a flat surface.
3. Push the pins of the
interchanger (1) into the change
holes of the collet chuck (2).
Operation
86