Dangers Due To Flying Parts; Eye Injuries Due To Sharp Chips; Skin Irritation Due To Operating Materials; Procedure In The Event Of Danger And Accidents - Rohm CAPTIS-M Traducción De Las Instrucciones De Servicio Originales

2.6.1 Dangers due to Flying Parts

During operation, the connection between the clamped part and collet
chuck CAPTIS-M may become loose due to mechanical failure (e.g. due
to defective parts) or incorrect operation (e.g. excessive speed). The
clamped part may then fly out and cause serious crushing and impact
injuries.
To prevent cutting and crushing injuries, ensure perfect functioning of the
collet chuck CAPTIS-M before each operation.
Also ensure that unauthorised persons cannot rotate the collet chuck
CAPTIS-M unintentionally.

2.6.2 Eye Injuries due to Sharp Chips

Sharp metal chips may be produced during machining of metal. During
operation or when blowing out the collet chuck CAPTIS-M with blower air,
the sharp metal chips may be stirred up and cause eye injuries and cuts.
To prevent eye injuries and cuts, wear eye protection and hand protection
during operation and cleaning work.

2.6.3 Skin Irritation due to Operating Materials

During maintenance work, there is a possibility of coming into contact with
lubricant. The lubricant consists of substances which may lead to skin
irritations in the event of frequent skin contact.
In order to minimise the risk of skin irritations, wear long work clothing and
avoid contact with the lubricant.

2.6.4 Procedure in the Event of Danger and Accidents

In the event of danger and accidents, it must be ensured that first aid
measures can be taken immediately.
1. Shut the machine down immediately via the Emergency-Stop button.
2. Remove the person involved from the danger zone and sit or lay the
person down.
3. Call a doctor.
 Do not make any changes to the accident site.
4. Administer first aid.
 Stop any bleeding.
 Cool burns.
5. Report all accidents to a superior.
122017 / 1.0
Safety
59