Taking A Measurement - Braun ExactFit 1 Manual De Instrucciones

5 . When the cuff is positioned properly, press the Velcro firmly against
the pile side of the cuff .
6 . This cuff is suitable for use if the arrow heads fall within the stripe
pattern on the other side of the cuff when the cuff is tightened
around your arm (Fig . 5) .
7 . Sit on a chair and place your arm on the table so that the cuff is at the
same level as your heart (Fig . 6) .

Taking a measurement

8 . Sit on a chair with your feet flat on the floor .
9 . Wrap the cuff snugly around your arm
(see "Applying the arm cuff" section above,
Fig . 3-6) .
10 . Do not move the unit during measurement,
or the proper measurement will not be
achieved .
11 . Press power button
automatically . While measurement is in progress, do not move or
speak .
Note: If necessary to interrupt a measurement, press the power
button at any time . The device immediately cancels the
measurement, lowers cuff pressure and automatically turns off .
12 . The cuff will first inflate and then deflate . At the end of the
measurement there are 2 final beep sounds and the reading is
displayed:
Upper (systolic) value
Lower (diastolic) value
Pulse
13 . Press the power button
product will turn off automatically after 1 minute . If at any time you
want to stop the measurement, press the power button
14 . Test results will be saved into the memory automatically ( see
memory function below) .
to begin . The measurement starts
to turn the product off . Otherwise the
.
5