Installing The Control Unit Indoors - Graf one2clean Instrucciones De Instalación

5. Installing the control one2clean unit indoors
1.
The control unit should be installed in a dry, dust-
free indoor location. To install, drill two 8mm holes
in the wall.
3.
The compressor is placed on top of the control
unit. Use the rubber bracket for the air connection.
The compressor's connector is plugged into the
socket on the control unit.
5.
The aeration hoses are connected to the two 3/4"
hose connectors. The sludge return hose is con-
nected to the 1/2" connection.
Note one2clean plus control unit: The assembly of the one2clean plus control unit is to be carried out in the same
way as the one2clean control unit. The one2clean plus control unit is equipped with a third valve for the excess
sludge removal. Therefore the air distributor with the valves is not needed.
5. Installing the control one2clean unit indoors
The control unit is secured to the wall with the
dowels and screws supplied.
The hose for clear water extraction (1/2") is direct-
ly connected to the black hose connector on the
control unit. The additional air distributor is con-
nected to the control unit's blue hose connector
(3/4").
For information about starting up the wastewater
treatment system and setting the control unit, refer
to the operating logbook.
22 / 36
2.
4.