Troubleshooting Guide - Stanley FatMax FMFP12703 Manual De Operación Y De Mantenimiento

THREE YEAR LIMITED WARRANTY
STANLEY TOOLS ("STANLEY") warrants to the original retail purchaser that this
product is free from defects in material and workmanship, and agrees to repair or
replace, at STANLEY option, any defective product within 3 year from the date of
purchase. This warranty is not transferable. It only covers damage resulting from
defects in material or workmanship, and it does not cover conditions or malfunctions
resulting from normal wear, neglect, abuse, accident or repairs attempted or made
by other than our regional repair center or authorized warranty service center.
Driver blades, bumpers and o-rings are considered normally wearing parts.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS
LIMITED TO THE DURATION OF THIS WARRANTY. STANLEY SHALL NOT BE LIABLE
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES.
This warranty is limited to sales in the United States and Canada. Some states
do not allow limitations on how long an implied warranty lasts, or the exclusion
or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
To obtain warranty service, return the product at your expense together with proof
of purchase to a STANLEY regional or authorized warranty repair center. You may
also contact us at 1-888-848-5175 for the location of authorized warranty service
centers in your area.
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART
BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A STANLEY
BLACK & DECKER SERVICE CENTER OR CALL 1-888-848-5175.
To reduce the risk of serious personal injury, ALWAYS
disconnect air from tool before all repairs.
SYMPTOM
Air leak near
top of tool or in
trigger area
Tool does nothing or
operates sluggishly
Air leak near
bottom of tool

TROUBLESHOOTING GUIDE

PROBLEMS
Loose screws.
Worn or damaged
o-rings or seals.
Inadequate air supply.
Inadequate lubrication.
Worn or damaged
o-rings or seals.
Loose screws.
Worn or damaged
o-rings or bumper.
14 - ENG
SOLUTIONS
Tighten screws.
Install Overhaul Kit.
Verify adequate air supply.
Put 5 or 7 drops of
oil into air inlet.
Install Overhaul Kit.
Tighten screws.
Install Overhaul Kit.