Maintenance & Troubleshooting - Stanley Bostitch GFN1564K Manual De Instrucciones

MAINTENANCE & TROUBLESHOOTING
Remove the fuel cell and battery from the tool and
completely empty the magazine before starting
maintenance or repairs. Read and understand the
warnings in this manual, in the Tool Technical Data and
on the tool itself and use extra care when evaluating
problem tools.
Bostitch replacement parts are recommended. Do not
use modified parts or parts that will not give
performance equal to the original equipment.
CAUTION: Be sure to remove the battery and fuel cell
during clearing jams, inspection, maintenance and
cleaning.
JAM CLEARANCE
1. First, remove the fuel cell and the battery from the
nailer.
2. Remove all remaining nails from the magazine.
3. Release the lock lever by lowering the cover (Fig 28)
and open guide plate (Fig. 28).
4. Remove the jammed nail with a slotted-head
screwdriver or pliers (Fig. 29).
5. Close the guide plate and latch, ensuring it is closed
properly before proceeding.
NOTE: In case of frequent jams, consult the Authorised
Service Center from which you bought this machine.
INSPECTING THE MAGAZINE
1. First, remove the fuel cell and the battery from
the nailer.
2. Clean the magazine. Remove paper chips or wooden
chips which may have accumulated in the magazine.
Lubricate it with Bostitch gas finish nailer lubricant.
CHECKING MOUNTING SCREWS
At regular intervals, check every part for loose mounting
screws and tighten any loose screws found. Operating
the tool with loose screws will can be hazardous.
INSPECTING THE CONTACT ARM
Check if the contact arm can slide smoothly.
Clean the sliding area of the contact arm and use the
provided oil for lubrication from time to time.
This will enable a smooth operation and simultaneously
help to prevent the formation of rust.
PREPARATION FOR STORAGE
● When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
● Do not store the nailer in a cold weather
All manuals and user guides at all-guides.com
● Keep out of reach of children.
● Refer to all instructions in the previous 'Storage'
FUSE REPLACEMENT OF CIGARETTE LIGHTER
CONNECTING PLUG
CAUTION: For continued protection against risk of fire,
replace only with the same type and ratings of fuse in
the cigarette lighter connecting plug.
-250V, 6A, DC
SERVICE PARTS LIST
CAUTION: Repair, modification and inspection of
Bostitch Power Tools must be carried out by a Bostitch
Authorised Service Center.
The Parts List supplied with this tool will be helpful if
presented with the tool to the Bostitch Authorised
Service Center when requesting repair or other
maintenance.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS
Stanley Bostitch tools are constantly being improved and
modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
APPLICABLE LUBRICANTS
Use BOSTITCH Gas Nailer lubricant.
Do not use detergent oil or additives: these lubricants
will harm the O-rings and other rubber parts and will
cause the tool to malfunction.
NOISE AND VIBRATION DATA
NOISE EMISSION (See Tool Technical Data)
The characteristic noise values for the tool have been
determined in accordance with EN 12549 - "Acoustics -
Noise test code for fastener driving tools - Engineering
Method."
These values are tool related characteristic values and
do not represent the noise development at the point of
use. Noise development at the point of use will depend
for example on the working environment, the work piece,
the work piece support and the number of driving
operations, etc.
environment. When not in use, the tool should be
stored in a warm and dry place.
section of this manual.