Peavey XR 600G Manual De Operación página 11

35. AC Power Inlet: This is the receptacle for
the supplied IEC line cord. This provides
AC power to the unit. Connect the
supplied line cord to this connector to
provide power to the unit. Damage to the
equipment may result if improper line
voltage is used (see line voltage markings
on the unit).
36. Power: The main power switch for the
XR600G. The power on LED indicator
(front) will light when the unit is powered.
37. Fuse: This is the main safety fuse for the AC line voltage. Only replace with a fuse of the exact type and rating. If the
fuse continues to open‚ do not over fuse. Take the unit to an authorized Peavey service center.
VENTILATION: ALLOW 6" (15.5 CM) ON ALL SIDES FOR
PROPER VENTILATION.
38 & 39. Main/Monitor and Main Outputs: These
these jacks and to a speaker cabinet‚ you complete the signal chain. You will notice there are two pairs of jacks. The
two pairs are your two amplifier outputs. Two cabinets can be connected to each channel as long as the combined
impedance of the cabinets is not less than 4 ohms. (i.e.‚ two 8 ohm cabinets in parallel = 4 ohms‚ four 16 ohm
cabinets in parallel = 4 ohms‚ etc.)
38
1 ⁄ " jacks are the amplifier's outputs. By connecting a speaker cable to
4
11
35 36
39
37