Tabla de contenido
Publicidad
Display mode
Mode d'affichage
Modo de
indicación
Erase button
Touche d'effacement
Botón de borrado
LCD Monitor
Écran ACL
Monitor LCD
OK button
Touche OK
Botón OK
148
E
ONE-FRAME ERASE
You can delete pictures you do not want.
When the picture is protected or the write-protect adhesive
seal is placed on the card, the camera does not enter the
Erase mode. Either cancel the protection or remove the seal
in order to start erasing. (Do not use the seal again.)
1
Set the Mode dial to "
want to erase.
2
Press the Erase button, then press the OK button with
YES selected.
To cancel, press the Erase button again or select NO in the
screen above and press the OK button.
One-Frame erase is also available in the Index-Display
mode (p. 150) and the Close-Up display mode (p. 152).
See page 164 for performing All-Frame erase.
Caution:
Never open the card cover, eject the card,
remove the batteries, or pull the plug while
erasing pictures. It may destroy the data in the
card.
Do not press the Erase button while an image is
being loaded onto the LCD.
", and display the picture you
Publicidad
Tabla de contenido
