CAME Z Serie Manual De Instrucciones página 5

Other functions
- Automatic closing: The automatic
closing timer is automatically activated
at the end of the opening cycle.
The preset, adjustable automatic closing
time is automatically interrupted by the
activation of any safety system, and is
deactivated after a STOP command or
in case of power failure;
- Partial opening. Opening of the gate to
allow for foot traffic; activated by
connecting to terminals 2-3P and
adjusted with the AP-PARZ. trimmer.
With this function, the automatic closing
can vary in the following way:
1) Dip 12 set to ON: after a partial
opening, the time for automatic closing
functions independently
adjustment of the TCA trimmer and of
the position of Dip 1; it is set at 8 seconds.
2) Dip 12 set to OFF: after a partial
opening, the time for automatic closing
is adjustable only if Dip 1 is set to ON.
- Cycle lamp. The lamp which lights the
manoeuvring zone: it remains lit from the
moment the doors begin to open until
they are completely closed (including the
time required for the automatic closure).
In case automatic closure is not enabled,
the lamp remains lit only during
movement (E-EX), see p.16;
- Courtesy Light. A light that illuminates
the manoeuvring zone; after an opening
command, the light remains on for a fixed
time of 5 minutes and 30 seconds
(E-EX), see page 16;
-"Maintained action" function:
Gate operates only when the pushbutton
is held down (the radio remote control
system is deactivated);
- Pre-flashing for 5 seconds, while the
door is opening and closing;
- Master function ; the panel assumes all
the command functions when two paired
motors are used (see page 30);
- Slave function ; this panel is exclusively
controlled by the "MASTER"(see page 30);
- Enabling functions of partial stop or
reclosure during opening, normally
closed contact (2-CX), select one of the
two functions by setting dip
(see selection of functions);
- Type of command:
-open-close-reverse by button and
transmitter;
of the -open-stop-close-stop by button and
transmitter;
-open only by transmitter.
Adjustments
- Automatic closure time;
- Partial opening time.
Important! Disconnect the unit from the
main power lines before carr ying out any
operation inside the unit.
- 5 -