VWR Star-Beater Manual De Instrucciones página 13

INSTRUCTION MANUAL
Starting the milling process
• Press START/STOP key. RUN and TIME signal lights shine. The machine counts
down the time from set value.
Note: You cannot modify the time during the operation of the machine.
Changing the frequency during the operation
• If you want to change the vibrational frequency during the operation of the machine,
push ENCODER knob, so that the FREQUENCY signal light shines. Rotate
ENCODER right (+) or left (-) to required value. In the meantime FREQUENCY signal
light is flashing. When you stop rotating ENCODER knob, signal light FREQUENCY
stops flashing after 2 sec.
Stopping the milling process
• When the time elapses or when you press START/STOP key again, message "End"
appears on display and RUN signal light flashes. When the machine stops
completely, the last used values for time and frequency are automatically reset.
EN 13
VWR Star-Beater